+971 58 558 1295 ENTR Request a Quote
Warm wood sauna with wide glass door and windows overlooking an indoor pool, wooden bucket

[ Project ]

Istinye Park Residence

Istanbul · Türkiye

Sauna Dekor Spa Solutions — designing, manufacturing and installing saunas, steam rooms, hammams and pools since 1987, in our own facility in İkitelli OSB, Istanbul.

Indoor pool hall, sauna and steam room built for Istinye Park Residence, Istanbul — pool-hall air handling, unattended safety and tanking in a tower.

  • Sauna
  • Steam room
  • Pools

Project summary

What we delivered

  • Rooms: Steam Room, Sauna, Pools
  • Where and when: Istanbul · Türkiye, 2019
  • Equipment: Condair steam generator

[ 7 photos ]

From the project

Pool
Steam room
Pool
Sauna
Pool
Sauna

[ The build ]

01

Sauna, steam room and indoor pool hall at Istinye Park Residence

Project facts: Delivered 2019 · İstinye Park, Istanbul, Türkiye · Scope: steam room, sauna, pools · Equipment: Condair steam generator

Sauna Dekor has been building saunas, hammams, steam rooms and wet spa areas since 1987 — this is our 40th year. We manufacture in İkitelli, Istanbul and take single-point responsibility for design, production, installation and commissioning. 41+ countries to date.

This page records the residents’ spa at Istinye Park Residence in the Sariyer district of Istanbul. The zones listed for the project are steam room, sauna and pools; the photographicrecord shows an indoor pool hall alongside the thermal rooms.

02

Scope of work: a timber sauna, a steam room and the pool hall build-up

A residential wellness floor built around an indoor pool hall, with a timber sauna and asteam room off it. The package covered the wet-area build-up and tanking, stone and mosaic, thecabin with its heater and control, the steam generator and head, ventilation terminals,drainage and commissioning.

03

The pool hall is the building risk

An indoor pool inside a residential tower is not primarily a water-treatment problem; it isa building-physics problem. Water evaporates continuously, the vapour finds the coldest surface in the hall — normally the glazing or an under-insulated soffit — and condenses there, out of sight, for years. The remedy is a dehumidified supply air system, extract enough to hold the hall slightly negative against the residential side of the building, and warm air deliberatelywashed across the glass. If the hall is allowed to go positive, that moist air migrates intolobbies, lift cores and eventually apartments, which is a far more expensive fault to correct than to prevent. Seeindoor swimming pooland pools.

04

Sauna and steam room for unsupervised residential use

Residents use the sauna and steam room without staff present, so the rooms are specified tobe safe unattended: guarded heater with the correct clearances, control outside the cabin witha maximum setpoint and an automatic run-time cut-off, steam head low and away from every seat,outward-opening doors without locks. Sizing follows general practice — roughly a kilowatt ofstone-heater output per cubic metre of cabin volume with additions for glazing and masonry, anda steam enclosure sized on volume with a correction for the finish and reserve for dooropenings. A timed pre-heat run by building management gives the rooms a usable evening peak.

05

Tanking, acoustics and finishes

Wet rooms were tanked before finishes: bonded membrane over the screed, reinforcing tapeinto every corner, movement joint and penetration, dressed into the gullies, carried up past splash height, falls formed in the screed, epoxy grout in the permanently wet zones. In a tower this is structural protection, not decoration. Plant is isolated on anti-vibration mounts and kept off the slab, because pumps and a generator that transmit into the structure are audible in apartments and become complaints rather than snags. Slip resistance and the wet-to-dry floor threshold around the pool are specified together.

06

What we solved on site

The wellness floor sits inside a completed residential building, so the constraint was working around occupancy: service-route deliveries at agreed hours, no cutting on site, and a sequence that kept circulation open. Everything was manufactured and dry-assembled in ourIstanbul workshop and delivered in numbered lots.Handover covered the pre-heat and shutdown routine for building management. More atservices,sauna andsteam room.

07

Frequently asked questions

What is the main risk with an indoor pool in a residential tower?

Condensation. Vapour from the water finds the coldest surface — usually glazing or an under-insulated soffit — and condenses there unseen. The hall needs dehumidified supply, enough extract to stay slightly negative, and warm air washed over the glass.

What happens if the pool hall goes positive?

Moist air migrates into lobbies, lift cores and eventually apartments. That is far more expensive to correct than to prevent, which is why the pressure regime is fixed at design stage rather than adjusted later.

How are unsupervised thermal rooms made safe?

Guarded heater with correct clearances, external control with maximum setpoint and automatic run-time cut-off, steam head low and away from seats, and outward-opening doors without locks.

Why is plant isolation part of the spa package?

Because pumps and generators transmitting into the slab are audible in apartments. Plant is mounted on anti-vibration supports and kept off the structure as part of the design, not as a remedial fix.

Sauna Dekor’s own certification is TS EN ISO 9001:2015 quality management, covering sauna and spa product manufacturing and after-sales service. The equipment we install carries CE / EN 60335, TÜV, GS, GREENGUARD Gold, FSC and VDI 6022 certification from its own manufacturers — EOS, Sentiotec and Condair among them.

Portfolio

Similar projects: same rooms, country or type of building

Have a similar project?

Send us your plan; we will work out the scope and the rooms it needs.

Last updated:

[ Related pages ]

Ready to learn more?

Book a consultation or speak with our team.

We’d love to cooperate
TO BUILD AMAZING POOLSAUNATURKISH BATH & HAMMAMSNOW ROOMSTEAM ROOMSALT ROOMWHIRLPOOL

Sauna Dekor Spa Solutions

Sauna Dekor Spa Solutions was established in 1987. In order to spread the use of Spa & Wellness, it introduced its products in many international fairs and followed the innovations abroad and examined the Spa & Wellness culture on-site, and made perfect applications with quality materials and correct manufacturing techniques.

Talk to our team

Dubai office · Istanbul factory

WhatsApp+90 532 215 64 78Call Dubai+971 58 558 1295Request a quote