+971 58 558 1295 ENTR Request a Quote
Indoor pool under a timber coffered ceiling with fluted stone walls and lit floor panels

[ Project ]

Le Meridien Hotel

Batumi · Georgia

Sauna Dekor Spa Solutions — designing, manufacturing and installing saunas, steam rooms, hammams and pools since 1987, in our own facility in İkitelli OSB, Istanbul.

Sauna and swimming pool areas built for Le Meridien Batumi, Georgia — pool-hall air handling, humid coastal material choice and tanking practice.

  • Sauna
  • Swimming pool
  • Pools

Project summary

What we delivered

  • Rooms: Sauna, Swimming Pool
  • Where and when: Batumi · Georgia, 2014
  • In short: Sauna and swimming pool areas built for Le Meridien Batumi, Georgia — pool-hall air handling, humid coastal material choice and tanking practice.

[ 3 photos ]

From the project

Sauna
Pool

[ The build ]

01

Finnish sauna and pool hall at Le Meridien Batumi

Project facts: Delivered 2014 · Batumi, Georgia · Scope: sauna, swimming pool

Sauna Dekor has been building saunas, hammams, steam rooms and wet spa areas since 1987 — this is our 40th year. We manufacture in İkitelli, Istanbul and take single-point responsibility for design, production, installation and commissioning. 41+ countries to date.

This page records the sauna and swimming pool areas built for Le Meridien in Batumi, Georgia.The zones listed for the project are sauna and swimming pool.

02

Scope of work: a timber Finnish sauna cabin and the pool hall wet finishes

A hotel leisure package rather than a full thermal circuit: a timber sauna cabin and the wet finishes and detailing around the indoor pool. Our contract covered the cabin with its heater and control, the tanking and falls in the wet areas, the finishes, ventilation terminals andcommissioning.

03

The pool hall is the engineering problem

Batumi sits on the Black Sea in one of the wettest subtropical climates in the region, and that makes an indoor pool hall harder rather than easier: the outside air is already close to saturation for much of the year, so it cannot be used to dry the hall. The system therefore hasto dehumidify mechanically rather than dilute with fresh air, hold the hall slightly negativeagainst the dry side of the hotel so vapour does not migrate into corridors and guest floors,and wash warm air across the glazing so condensation does not form on the coldest surface inthe room. Getting this wrong is not a visible defect on handover; it is a slow failure inside the building fabric. Seeindoor swimming pooland pools.

04

Finnish sauna specification for hotel duty

The cabin is sized by general practice at roughly a kilowatt of stone-heater output percubic metre of volume, with additions for glazing and for masonry surfaces inside the envelope.For hotel duty the heater is a commercial unit with serviceable elements, the control sits outside the cabin on a timer with a maximum setpoint, and benching is built in liftablesections. Air comes in low near the heater and leaves low on the opposite side, ducted back into the building rather than dumped into the changing room. Product page:sauna.

05

Finnish sauna cabin materials in a permanently humid climate

In a climate this damp, timber selection and the cabin build-up matter more than they wouldinland. Boards are kiln-dried and low in resin, the cabin is built as an insulated box with a continuous foil vapour barrier and taped laps, and a ventilated cavity sits behind the lining so the back of every board can dry between sessions. Exposed metalwork near the coast is chosen for the environment. Wet areas were tanked before finishes: bonded membrane over the screed,reinforcing tape into corners, movement joints and penetrations, falls formed in the screed,epoxy grout where the surface is permanently wet.

06

Where the Finnish sauna takes its make-up air in Batumi

The decision that mattered most was where the cabin’s fresh air came from. In Batumi, air taken straight from outside is close to saturation for much of the year, and a sauna ventilated that way never becomes genuinely dry — the timber stays damp and the room disappoints. We tooksupply from the conditioned interior instead and ducted the extract back into the hotel’ssystem. The cabin was manufactured and dry-assembled in ourIstanbul workshop, then numbered and shipped.More at hotel spa design.

07

Frequently asked questions

Why is a humid climate harder for an indoor pool hall?

Because the outside air is already close to saturation and cannot be used to dry the hall. The system has to dehumidify mechanically, hold the hall slightly negative against the dry side of the hotel, and warm the glazing.

Where should sauna make-up air come from in a very humid city?

From the conditioned interior. Air drawn straight from outside in a subtropical coastal climate keeps the cabin from becoming genuinely dry and leaves the timber damp between sessions.

How is a cabin built to survive permanent humidity?

As an insulated box with a continuous foil vapour barrier and taped laps, a ventilated cavity behind the lining so each board can dry from the back, and kiln-dried, low-resin timber throughout.

What does hotel duty change about the sauna heater?

It becomes a commercial unit with serviceable elements, with the control cabinet outside the cabin on a timer and maximum setpoint, and benching built in liftable sections for replacement.

Sauna Dekor’s own certification is TS EN ISO 9001:2015 quality management, covering sauna and spa product manufacturing and after-sales service. The equipment we install carries CE / EN 60335, TÜV, GS, GREENGUARD Gold, FSC and VDI 6022 certification from its own manufacturers — EOS, Sentiotec and Condair among them.

Portfolio

Similar projects: same rooms, country or type of building

Have a similar project?

Send us your plan; we will work out the scope and the rooms it needs.

Last updated:

[ Related pages ]

Ready to learn more?

Book a consultation or speak with our team.

We’d love to cooperate
TO BUILD AMAZING POOLSAUNATURKISH BATH & HAMMAMSNOW ROOMSTEAM ROOMSALT ROOMWHIRLPOOL

Sauna Dekor Spa Solutions

Sauna Dekor Spa Solutions was established in 1987. In order to spread the use of Spa & Wellness, it introduced its products in many international fairs and followed the innovations abroad and examined the Spa & Wellness culture on-site, and made perfect applications with quality materials and correct manufacturing techniques.

Talk to our team

Dubai office · Istanbul factory

WhatsApp+90 532 215 64 78Call Dubai+971 58 558 1295Request a quote